Making an e-Paper Etch-a-Sketch

epaper-etch-a-sketch

Scott Baker has been working on making an Etch-a-Sketch using modern e-Paper displays and optical encoders:

Above you can see my prototype. I’m using a 4.2″ e-Paper display from Gooddisplay, together with the Waveshare breakout board. I have a couple of ENS1J-B28-R00128 optical encoders that I attained on eBay. I specifically chose these encoders instead of traditional electro-mechnical encoders due to the high numbers of pulses per revolution. A typical electro-mechanical encoder will net about 24 pulses per revolution. The optical encoders I bought on ebay are 128 pulses per revolution. Our 4.2″ ePaper has 400×300 pixels. To traverse the major axis would require 16 full turns of the electromechical encoder but only 3 turns of the optical encoder.
The hardware is so simple that there’s not much more to say. The encoders are connected to GPIO pins of a Raspberry Pi. Note that there are resistors inline on the encoder outputs as the encoders are 5V and the Raspberry Pi uses 3.3V GPIO. The e-ink display is connected to the SPI bus.

See the full post on his blog here and the GitHub repository here.

Check out the video after the break.

Fascinating details of Waveshare e-paper displays

image1

Erich Styger has a nice write-up on Waveshare e-paper displays:

I have used E-Ink displays in projects three years ago, but from that time the technology has greatly evolved. That time displays were hard to get, expensive and difficult to use. Now things seem to change with e-ink displays available to the maker market :-). I’m able to get a 128×296 pixel e-paper display for $10! And for little more money I can have displays with black/white/red colors!

More details at MCU on Eclipse homepage.